Belt conveyors, both Troughed and Flat are manufactured according to the plant / project’s requirement.Basic and detailed engineering for any type of application is developed by us, and the system parts are delivered to the customer’s location for on site assembly. SELECTION CHART – TRIPLE ROLLER TROUGHED TYPE BELT CONVEYORS SELECTION CHART – FLAT BELT & TWO EQUAL IDLER TROUGHED TYPE BELT CONVEYORS CAPACITY CALCULATION -  The surcharge angle is dependent upon a given materials physical property -   The Trough idler angle selection also depends upon the physical properties     of the material proposed to be handled. Deep angle cannot be used for     light density material. Also deep idler trough angle cannot be used with thick     section belts. Deep trough idler angle must be used for larger belt widths. -  The area of cross section derived from the above chart is multiplied by belt     speed. Material bulk density to work out Belt     conveyor capacity as     kg/hour. It is advised that selection of Belt conveyor be finalized in consultation with an experienced material handling systems engineer. Belt conveyors can be operated with inclined orientation without loss of capacity, however the inclination angle must not exceed the slide back angle of the material proposed to be handled. The following special parts and associated equipment can be supplied with the Belt conveyors:- - Material inlet chutes, with or without dust control hoods - Material delivery chutes, with or without dust control hoods - Conveyor skirt boards - Conveyor side boards - Weather protection covers and assemblies - Weather protection covers and assemblies