Filteration area
Cartridge Dia
Cartridge Length
No. of Cartridges
Dust laden Air flow rate, m3/hour
Filter overall dimension, mm
M2
mm
mm OD
Air cloth ratio, m3/min/m2 0.75
Air cloth ratio, m3/min/m2 1.0
Air cloth ratio, m3/min/m2 1.5
Air cloth ratio, m3/min/m2 2.0
Length
Width
Height
 
Silo filters have fabricated body which are full open from the bottom. These filter units are installed directly atop the Silo / Hopper which needs a dust abatement device since it is receiving loose bulk material either through a mechanical conveyor e.g. Bucket elevator or Belt conveyor, or through a Pneumatic conveying system.
Air to cloth ratio is akin to the service factor of the application. The more severe the Dust load, lower value of Air cloth ration must be used. For fine mesh material, again lower air cloth ratio must be used. In case the application is Pneumatic conveying system, lower air cloth ration must be used.
Most commonly used filtration media is spun bonded polyester, with internal cage of molded plastic. However, other filter media for higher service temperature up to 190 / 230°C are available. Filter media with inter woven metal wire, or Carbon powder impregnated for Anti static properties are also available.
The filtration media used are Cartridge filters of spun bonded media, pleated construction, in lengths of 1000, 1500 & 2000 mm.
The filters are on line cleaned using reverse pulse of Dry compressed air. The control valve used for delivering the compressed air is a full bore diaphram type solenoid valve which are inherently capable of delivering large volume compressed air is short operating cycles
Usually the filters are cleaned on line, row by row. However, for certain types of very fine dusts of low density materials, filters with off line cleaning design can also be offered.
 

|| Home || About us || Quality Policy || Production Program || Belt Conveyors || Silos ||
|| Screw Conveyors || Silo Filters || Filter Bag Houses || Screw Augers || Pipeline Aligning Jigs|| Contact us || Feedback ||